square to round development software free download

The user can define here what diameter type will be applied. The parts are joined to each other using the allowances set up in the seam specified for Length Break S2 on the Connectors tab. The breaks will always be at equal spacing along the centreline of the pattern. The user can enter a value here to determine the number of times that the development will be broken across the length of the pattern. When set to 8, 4 flat side parts and 4 round corner parts are always produced, regardless of the seam position setting. If 1, 2 or 4 is selected the position of these breaks will depend on the value of the Seam Position described below. This option allows the user to determine how many parts the fitting will be made. The Square to Round pattern also has some are pattern options which are exclusive to this pattern. Note: These options only affect entered values they do not affect preset values such as Flat Top, Flat Left etc. The different options here are Bottom Up, Bottom Down, Top Up or Top Down.For specific details on these options Taper Pattern. For specific details on these options Taper Pattern. The different options available here are Left In, Left Out, Right In or Right Out.

By default on a standard installation these are set as below. The direction in which entered values are measured are controlled by the settings for Offset Width (7) and Offset Depth (8) on the Options tab. This can be an entered value, Flat Bottom, Flat Top or Central.

The Offset Depth (F)dimension controls the offset top to bottom across the depth of the duct.

In this case entering a zero value would give the same result as choosing Flat Left. This can be an entered value, Flat Left, Flat Right or Central. This can be seen in the top left view of the image above.

The Offset Width (E) dimension controls the offset left to right across the width of the duct.

The amount that a square to round offsets is defined by the amount entered in the Offset Width (E) and Offset Depth (F) fields in the dimensions tab during pattern takeoff. The offsets and other features of the square round are detailed below. In which case it is essential that the user know which offset dimensions are being requested and how to change them if necessary. Similarly to the Taper Pattern, it also often has a double offset.

The Square to Round pattern is a commonly used fitting and many variable dimensions and options.

Square to round development software free download